-
The BP440 laser bandpass filter is suitable for scenes with strong and uncontrollable natural light. The cutoff depth of OD4 can significantly reduce ambient light interference and improve the signal-to-noise ratio during PIV measurement. -
LP500 and BP525 filters are used with FPP440/530 fluorescent particles. LP500 can provide excellent fluorescence signal intensity at a lower cost. The BP525 is a band-pass filter. Similar to the BP440, it is suitable for scenes with strong ambient light and is used to improve the signal-to-noise ratio. -
LP500 and BP525 filters are used with FPP455/530 fluorescent particles. LP500 can provide excellent fluorescence signal strength at a lower cost; BP525 is a bandpass design, similar to BP455, suitable for scenes with strong ambient light to improve the signal-to-noise ratio. -
The PP455/530 series products are the latest generation of fluorescent particles dedicated to PIV. Compared with traditional fluorescent particles, on the one hand, its wavelength is suitable for RapidPulse series lasers, and on the other hand, its density is 1.00g/cc, which perfectly matches the density of water and can ensure long-term suspension in water without settling. Generally speaking, 1.03g/cc PSP particles can ensure about 4 hours of suspension time, while 1.15g/cc traditional fluorescent particles can only be suspended for about 20 minutes. Therefore, the FPP455/530 series products can greatly improve the measurement accuracy of PIV and are suitable for a wider range of applications. -
A family of highly sensitive cameras based on back-illuminated sensors Advantages- The whole line is equipped with back-illuminated high-sensitivity sensors as standard
- The PLIF cameras are deeply cooled and have a 16-bit dynamic range
- Up to 12um pixels to meet the requirements of ultra-high sensitivity
- The 27mm diagonal length fits perfectly with the 25mm image intensifier with a 10:11 relay mirror
- Full PLIF precise time synchronization requirements
-
The product matrix covers 100Hz/MHz, ultraviolet/visible light use requirements Advantages- The whole line is equipped with a 25mm imaging aperture as standard, with flexible relay lens configurations, to meet the needs of different sensor sizes
- Door widths as short as 5ns are standard across the line – with no exit restrictions
- Optional 3rd generation visible light enhancement – no export restrictions
- Integrated high-precision signal generator – the control hub of the imaging system
- Low noise, wide gain usable range
- Extremely high resolution at the imaging end to meet the needs of small-pixel cameras
-
Quasi-CW laser for PIV Advantages-
- The best cost-effective illumination solution for HSFB based PIV
- Meet the PIV measurement requirements of most low-speed water flow and spray applications
- Maximum repetition rate up to 100kHz
- Supports double-frame function for low-frequency PIV cameras
- Maximum peak power 20W or 30W, higher power upon request
-
Subscribe to our newsletter.
© Copyright 2004 - 2025 Rapid Image Technology Limited All Rights Reserved